SL 200 Levelling Mortar which Spreads Automatically and Covering Mortar
Description: It is the concrete based levelling mortar which is polymer, modifiable, and which has an only ingredient. It can be applied by pumps. If it s used as the last layer, light grey, beige, red and green are available. Application Areas: Workplaces whose traffic burden is not heavy, floors of stores, buildings, and industry, it is used as a levelling mortar onto old or new concrete. Features: It constitutes the ground underneath the floor coats. (linoleum,PVC, carpet, epoxy, parquet, ceramics, marble etc.) It is easy to apply. By dispersing itself, it eradicates the asperity of the ground where it is applied. It is suitable for the grounds which are heated from the ground. It is opened for the pedestrians in a short time. The toughness of the surface and the resistance of corrosion are quite high. Application: The preparation of the surface: If the application is going to be done on a new concrete, it must have taken its cure. The surface on which the practice is done must be clean and purified from all kinds of substances such as dust, oil, dirt, and the substance that prevents adherence. The ground must be lined with SL undercoat. The preparation of the mortar: For a 25 kg plastic bag, 5 – 5.5 kg water is put into a suitable pot. SL 200 is slowly added to the water by means of a mixer with low speed. It is mixed till it becomes homogeny. (3 – 5 minutes). The application of prepared mortar: After the mortar is poured to the surface, it is scattered with the help of a suitable trowel till it reaches the intended thickness. A hedgehog roll is used to remove the bubbles. The thickness of application is 5 – 15 mm once. If the application is done thicker than 15 mm, it is needed to be applied as layers. In order to protect, cure material should be applied before the mortar dries. The mortar should be used in advance. (10- 30 minutes) Technical Information: Package : a 25 kg barrel, a 1 tone palette Colour : concrete grey, light grey, beige, red, green Density : 1.8 kg / litre of dry powder Application Temperature: + 5°C and + 30°C Storing : In its original package, 6 months in dry conditions (at + 5°C and + 30°C ). Consumption : 1,8 – 2kg./ mm. / m² |